Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Wellington Homeowners
A broken garage door spring in Wellington usually shows up the same way: you press the remote, the opener hums, and the door barely moves, or it slams down hard. Springs carry the full weight of the door, so when one fails the door becomes heavy and unsafe to lift by hand. Our technicians have up to 11 years of experience with torsion and extension springs on the brands most Wellington homes already have, and we offer same-day spring repair for doors that won’t open. Call (855) 658-3814 and we’ll get a specialist out to look at it.

What Our Garage Door Spring Repair Service Includes
Spring work is the part of garage door service where brand knowledge and safety matter most. Every job we take on is handled by a garage door specialist, not a general handyman squeezing in a door call between other work. Here’s what each part of the service covers.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on a metal shaft above the door, and it does the lifting work as the door opens and closes. When it breaks, you’ll usually hear a loud bang and the door won’t rise more than a few inches. We replace torsion springs matched to your door’s weight and height so the door balances correctly instead of straining the opener.
Extension Spring Replacement
Extension springs run along the horizontal tracks on each side of the door and stretch as the door closes. Older Wellington homes often still have them, and they wear out faster than torsion springs because they stretch every single cycle. We replace them in matched pairs, since a new spring next to an old one throws the door out of balance.
Broken Spring Repair
When a spring snaps, the door becomes dead weight and the opener can’t safely lift it. This is the call we get most often, and it’s one you shouldn’t try to fix yourself: high-tension springs store enough energy to cause serious injury if handled without the right tools. We diagnose which spring failed, check the other one for wear, and get the door working again the same day in most cases.
Spring Adjustment
Sometimes the spring isn’t broken, just out of tune. If your door drifts down on its own, feels heavier than it used to, or the opener strains to lift it, the tension needs adjusting. We reset the spring tension so the door balances at the halfway point and the opener isn’t working harder than it should.
Safety Cable Installation
Extension springs need safety cables running through them so that if a spring breaks, the pieces stay contained instead of flying across the garage. Many older doors were built without them. We install safety cables on any extension spring setup that’s missing them, which is one of the simplest safety upgrades you can make.
Spring Inspection
A spring can be close to failing long before it breaks, and a visual inspection catches the warning signs early. We look for gaps in the coil, stretched sections, rust, and uneven wear between the two springs. If your door is more than a few years old and you’ve never had the springs checked, an inspection is worth the call.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on the brand you already have. Wellington homes have a wide mix of doors, and we service spring systems on Wayne Dalton and Craftsman doors, along with LiftMaster and Raynor setups and most other major makes. Each brand has its own spring sizing and mounting setup, and knowing those differences means we bring the right spring the first time instead of making a second trip.
Wayne Dalton doors often use proprietary spring and torque setups that generic repair techs aren’t familiar with, and we know where those wear out. Craftsman and LiftMaster doors tend to have straightforward torsion systems, but the spring size still has to match the door’s weight exactly. Raynor doors use their own hardware, and getting the spring tension right on them takes brand-specific know-how. Whether you have a Wayne Dalton, Craftsman, Raynor, or LiftMaster door, we can help, and if it’s another make, we’ll still take a look. Garage doors are all we do, which means the technician at your door works on these systems every day.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That sound is usually a torsion spring snapping, and it often happens when no one is in the garage. If you heard it, don’t run the opener again until someone checks the springs.
- The door won’t lift more than a few inches. A door that rises slightly and stops has lost its spring tension, and the opener is trying to lift dead weight. Running it that way can burn out the opener motor too.
- The door feels extremely heavy when you lift it by hand. A properly balanced door lifts with one hand. If it takes real effort, the springs aren’t doing their job, and that’s a sign to stop lifting it.
- A visible gap in the spring coil. Look at the spring above the door: a clean break leaves a gap you can see. Rust streaks or a stretched section on an extension spring are warning signs of one about to fail.
- The door slams down or drifts open on its own. Uneven tension makes the door fall fast or creep up when it should stay put. That’s a balance problem the springs need to fix.
Our Garage Door Spring Repair Process – Step by Step
- 1
We take your call and ask the right questions. Tell us what the door is doing and what brand it is, and we’ll get a sense of whether it’s a spring issue before we arrive. That helps us bring the right parts and give you a realistic time window.
- 2
We inspect the whole spring system on arrival. We check both springs, the cables, the drums, and the balance of the door. A broken spring often comes with a worn cable or a bent track, and we want the full picture before quoting anything.
- 3
We give you a written price before any work starts. You’ll know exactly what the repair costs and what it includes before we touch the door. The price we quote is the price you pay, and we don’t start until you’ve agreed to it.
- 4
We replace the spring with the right match. We use winding bars and proper tools to release the tension safely, then install a spring sized to your door. Matched pairs go in together so the door stays balanced.
- 5
We test the door and walk you through it. We cycle the door several times, check the balance, and make sure the opener isn’t straining. Then we show you what we did so you know what to listen for in the future.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Wellington?
A typical spring repair in Wellington runs $180 – $340 for one spring, depending on the type of spring, the door’s size, and whether a cable or other part needs replacing at the same time. A matched pair is usually replaced together, so a pair costs about twice that range. Here’s how the common scenarios break down:

| Service | Typical Estimated Range |
|---|---|
| Single spring repair (torsion or extension) | $180 – $340 |
| Matched pair of springs | About twice the single-spring range |
| Spring adjustment | Falls within the spring repair range |
| Safety cables (with spring work) | Added to the spring estimate |
| Cable repair, if a cable failed too | $130 – $250 |
A few things move the price: the spring type, whether it’s a single or a pair, the door height, and any related parts like cables or drums that also need work. You avoid overpaying by getting a written estimate before work starts and asking what’s included.
Our estimates are free, and we’ll tell you what the job needs and what it doesn’t. If your springs are fine and the real problem is an opener or a track, we’ll say so.
Garage Door Spring Repair Near Wellington – Our Service Area
We handle spring repair across Wellington and the surrounding communities, including Royal Palm Beach, Loxahatchee Groves, Greenacres, and Belle Glade. If you’re further out toward Jupiter Farms or Tequesta, we can still get a technician to you, and we’ll give you an honest time window when you call. Our Wellington Garage Door Repair Pros team keeps spring work moving fast so your door isn’t stuck open or stuck shut. If you’re outside Wellington, we also handle garage door spring repair in Jupiter Farms and garage door spring repair in Tequesta.
Serving Wellington, FL – Our Local Coverage Area
We serve Wellington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Wellington
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance your door’s weight. When a spring breaks or loses tension, the door becomes too heavy for the opener to lift safely. Repair means installing a properly sized spring, or pair, and resetting the balance. Call (855) 658-3814 and we’ll tell you what your door likely needs.
Most spring repairs take about an hour to 90 minutes once we’re on site, depending on whether it’s one spring or a pair and whether other parts need work. A straightforward torsion spring replacement is usually quicker than an extension spring job on an older door. We’ll give you a realistic time estimate when you call.
A typical spring repair in Wellington runs $180 – $340 for one spring, and a matched pair is usually replaced together, so a pair costs about twice that. The final price depends on the spring type, door size, and any related parts. The written estimate sets the final price, and it’s free. Call (855) 658-3814 for an exact quote.
Yes, we service spring systems on Wayne Dalton and Craftsman doors, along with LiftMaster, Raynor, and most other major brands. Each brand has its own spring sizing and mounting, and our technicians know those differences. Tell us your door’s brand when you call and we’ll come prepared with the right spring.
In most cases, yes. A broken spring means your door is stuck, so we treat it as an urgent call and offer same-day spring repair whenever we can. Spring work is one of the reasons we’re set up for emergency service, not just scheduled installations. Call (855) 658-3814 and we’ll tell you the soonest we can get there.
We stand behind our work with a satisfaction guarantee, and the specific coverage depends on the parts and the job. We’ll explain exactly what’s covered when we give you the estimate, so there are no surprises. If something isn’t right after the repair, call us and we’ll make it right.
Clear the area under the garage door and move your car out of the way so the technician has room to work. Don’t try to open or close the door once a spring has broken, and don’t attempt a DIY fix on a torsion spring, since the stored tension can cause serious injury. Just let us know the door brand and what it’s doing, and we’ll handle the rest.
Schedule Your Garage Door Spring Repair Service in Wellington Today
A broken spring won’t fix itself, and running the opener on a door with a failed spring can damage the motor too. Call (855) 658-3814 for a free, no-obligation estimate on garage door spring repair, and we’ll get your door working safely again. Our team is ready.
Written by the team at Wellington Garage Door Repair Pros.